The Grand Rio

Instructions

Walk-in Tub

Press “ON” button on the control panel.  

Pull the handle at the front of the tub counter clockwise to seal in the water. 

Pull up handle inside tub to open, push door in and step into tub. Close the door behind you and and push it down handle all the way to make sure the door is sealed. Sit down in tub and turn on the water. You may want to turn on the seat heater at this time. 


*It will take about nine minutes to fill the tub with water. 


Once the water is above the jets in the back of the seat. You can now push the water button to turn on the jets. There is a knob next to the hand sprayer to target the jets on your back or your feet. 

To use the hand sprayer pull up on the rod behind the water spout. Push it down to turn the hand sprayer off. 


When you are finished and ready to get out turn the handle that you used to seal the tub clockwise and the water will start to drain. This takes about three or four minutes. You must wait for all the water to drain before you open the door or the water will flow out onto the floor. 

Pull up on the door handle open it and step out. Now you can turn off the tub by pushing the power button on the control panel.